UEFI boot
recovery
jumper (J59)
SW2
switch block
12345678
1
2
3
OFF
Attention: Before you change any switch settings or move any jumpers, turn
off the server; then, disconnect all power cords and external cables. See the
safety information that begins on page “Safety” on page v. Do not change
settings or move jumpers on any system-board switch or jumper blocks that are
not shown in this document.
The default for all of the switches on switch block (SW2) is Off.
While the server is turned off, move switch 3 of the switch block (SW2) to the
On position to enable the power-on password override. You can then start the
Setup utility and reset the power-on password. You do not have to return the
switch to the previous position.
The power-on password override switch does not affect the administrator
password.
138 System x3690 X5 Types 7147, 7148, 7149, and 7192: Installation and User's Guide
To Next Page
Loading...
