19
Cool Mode
• In this mode, the thermostat controls the cooling system. When the
cooling outputs, the snowflake icon apprears on the display.
Note: There is a four minute delay for your compressor to restart
after it has turned off. To bypass the compressor time delay,
go to OFF mode for 5 seconds.
Cool and Heat Mode (Auto Changeover)
• In this mode, the thermostat controls the cooling and heating systems,
automatically changing over from one to the other as needed.
• The timing display alternates with the set temperature every 10
seconds in the cool and heat mode.
Emergency Heat Mode (Heat pump systems only)
• In emergency heat mode, the heat pump system will be disabled and
auxiliary heat will become the primary source of heat.
To Next Page
Loading...
