Icom A120BE - Page 34

9
SPECIFICATIONS AND OPTIONS
9-2
Specications
In Canada, Use of 8.33 kHz Channel Spacing of this radio is strictly prohibited and shall not be used.
D General
• Frequency range:
IC-A120 118.000 to 136.99166 MHz
IC-A120E (AUS version) 118.000 to 136.97500 MHz
IC-A120E (Others) 118.000 to 136.99166 MHz
• Channel spacing: 25 kHz/8.33*
1
kHz
• Type of emission:
IC-A120 6K00A3E/5K60A3E (FCC/EXP)
6K00A3E (Industry Canada)
IC-A120E 6K80A3E/5K00A3E*
1
• Number of memory channels: 200
• Antenna impedance: 50 ø (nominal)
• Antenna connector: SO-239
• Power supply requirement: 13.75 V/27.5 V DC (negative ground)
• Current drain (at 13.75 V):
TX 5.0 A
Maximum audio 4.0 A
• Operating temperature range:
 IC-A120 –30˚Cto+60˚C,
   –22˚Fto+140˚F
 IC-A120E –20˚Cto+55˚C
• Dimensions:
(projections not included) 161 (W)✕45 (H)✕175 (D) mm,
6.3 (W)✕1.8 (H)✕6.9 (D) inches
• Weight (approximately): 1.5 kg, 3.3 lb
*
1
Except IC-A120E (AUS version).
D Transmitter
• Output power:
IC-A120 9 W (Carrier power) typical
10 W (Carrier power) maximum
 IC-A120E 9W±1.5dB(+15˚Cto+35˚C)
   9W+1.5dB/–3dB(–20˚Cto+55˚C)
• Frequency stability:
 IC-A120 ±5ppm(–30˚Cto+60˚C,–22˚Fto+140˚F)
 IC-A120E ±1ppm(0˚Cto+40˚C)
• Modulation system: Last stage modulations
• Audio frequency distortion:
IC-A120 Less than 10% (at 70% modulation)
 IC-A120E Lessthan10%(at85%modulation+3dB)
• Spurious emissions:
IC-A120 Less than –60 dBc
IC-A120E*
2
9 kHz to 30 MHz Less than –46 dBm
30 MHz to 1 GHz Less than –36 dBm (For Harmonics)
Less than –46 dBm (For Non-Harmonics)
1 GHz to 4 GHz Less than –30 dBm (For Harmonics)
Less than –40 dBm (For Non-Harmonics)
*
2
Except for operating frequency ±1 MHz.