6
3
PREPARATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
6
First, you must enter the 9 digit MMSI
(Maritime Mobile Service Identity: DSC
self ID) code at power ON.
■ Entering the MMSI code
+
Rotate
Push
+
Rotate
Push
Push
Push
Push
• After that, the Main screen is displayed.
The registered MMSI code is displayed
at the top of the screen.
• When you successfully enter your MMSI
code, the following screen is displayed.
y After entering the 9th digit, register
the ID.
• The MMSI CONFIRMATION screen is
displayed.
t Reenter your MMSI code to conrm.
r After entering the 9th digit, set the ID.
e Enter your 9 digit MMSI code.
• Push [CLR] to cancel the entry. In that
case, the transceiver displays “Push
[ENT] to Register Your MMSI” again.
q Hold down [ ] for 1 second to turn
ON the transceiver.
• Three short beeps sound.
• “Push [ENT] to Register Your MMSI” is
displayed.
w Push [ENT].
You can perform this initial code
entry ONLY ONCE. After entry,
only your dealer or distributor
can change it. If you have already
entered your MMSI code, these
procedures are not necessary.
To Next Page
Loading...
Need help?
General
