■ Advanced tuning functions
25
4
FREQUENCY SETTING
SELECTING THE 1 Hz STEP
The minimum tuning step of 1 Hz can be used for fine
tuning.
q Turn OFF the quick tuning step.
•“▼” does not appear.
w Push [TS] for 2 sec. to toggle the 1 Hz tuning step
ON and OFF.
•RIT and/or ∂TX also functions in 1 Hz tuning step
when used.
1/4 TUNING STEP FUNCTION (CW/RTTY only)
While operating in CW/RTTY, the 1/4 function is avail-
able for critical tuning. Dial rotation is reduced to 1/4
of normal when the 1/4 function is in use.
➥ Push [1/4] to toggle the 1/4 function ON and OFF.
AUTO TUNING STEP FUNCTION (AM/FM only)
When selecting AM or FM, the quick tuning step is
automatically selected by the auto tuning step func-
tion.
QUICK TUNING STEP
The operating frequency can be changed in kHz
steps (0.1, 1, 5, 9, 10, 12.5, 20 or 25 kHz selectable)
for quick tuning.
q Push [TS] momentarily to display the quick tuning
indicator.
w Rotate the tuning dial to change the frequency in
programmed kHz steps.
e Push [TS] again to turn OFF the indicator.
r Rotate the tuning dial for normal tuning if desired.
SELECTING THE kHz STEP
q Push [TS] momentarily to turn the quick tuning
step ON.
w Push [TS] for 2 sec. to enter the quick tuning step
setting display.
•Selected tuning steps for all modes appear.
e Select the desired operating mode.
r Rotate the tuning dial to select the desired tuning
step from 0.1, 1, 5, 9, 10, 12.5, 20 or 25 kHz.
t Repeat steps e and r to select quick tuning
steps for other modes, if desired.
y Push [EXIT] to exit the setting display.
To Next Page
Loading...
