35
5
RECEIVE AND TRANSMIT
■ Monitor function
The monitor function allows you to monitor your trans-
mit IF signals in any mode through the speaker. Use
this to check voice characteristics while adjusting
SSB transmit tones. (p. 65) The CW sidetone func-
tions regardless of the [MONITOR] switch setting.
q Push [MONITOR].
•The indicator lights when the monitor function is ON.
w Push [EXIT] one or more times to close a multi-
function screen, if necessary.
e Push [(F-5)SET] then [(F-1)LEVEL] to enter level
set mode.
r Push [(F-1)Y] or [(F-2)Z] to select the monitor
level item.
t Adjust monitor gain using the tuning dial.
•Pushing [(F-3)DEF] sets the selected item to the default
value of the item.
y Push [EXIT] twice to exit level set mode.
•Use headphones to prevent feedback.
•Set the transmit tone settings to the 0 dB posi-
tions to check the unaltered characteristics of
transmitter or microphone.
■ VOX function
The VOX (Voice-Operated Transmission) function tog-
gles between transmit and receive with your voice.
This function provides an opportunity to input log en-
tries into your computer, etc., while operating.
•Using the VOX function
q Select a phone mode (SSB, AM, FM).
w Push [VOX] to turn the VOX function ON or OFF.
•Adjusting the VOX function
q Select a phone mode (SSB, AM, FM).
w Push [VOX] to turn VOX function ON.
e Push [VOX] for 2 sec. to enter VOX set mode.
r Select the VOX gain item using [F-1] or [F-2].
t While speaking into the microphone, rotate the
tuning dial to the point where the transceiver is
continuously transmitting.
y Adjust the VOX delay for a convenient interval be-
fore returning to receive.
-Select the VOX delay item using [F-1] or [F-2].
-Rotate the tuning dial.
u If the receive audio from the speaker toggles to
transmit, adjust the anti VOX to the point where it
has no effect.
To Next Page
Loading...
