39
5
RECEIVE AND TRANSMIT
■ Digital voice recorder (continued)
•Recording a message for transmit
To transmit a message using a voice recorder, record
the desired message in advance as described below.
q Push [EXIT] one or more times to close a multi-
function screen, if necessary.
w Select a phone mode by pushing [SSB] or
[AM/FM].
e Push [(F-2)VOICE] to call up the voice recorder
screen.
r Push [(F-2)MIC REC] to select the voice memory
recording screen.
t Push the desired memory channel, [(F-1)T1]–
[(F-4)T4], for 2 sec. to start recording.
•Speak into the microphone without pushing the [PTT]
switch.
•Previously recorded contents are cleared.
y Adjust the [MIC GAIN] control so that the [MIC-
REC LEVEL] indicator reads within 100%.
u Push the selected memory channel, [(F-1)T1]–
[(F-4)T4], again to stop recording.
•Recording is automatically terminated after 15 sec.
i Push [EXIT] twice to exit voice memory screen.
•Confirming a message for transmit
q Push [EXIT] one or more times to close a multi-
function screen, if necessary.
w Select a phone mode by pushing [SSB] or
[AM/FM].
e Push [(F-2)VOICE] to call up the voice recorder
screen.
r Push [(F-2)MIC REC] to select the voice memory
recording screen.
t Push the desired memory channel, [(F-1)T1]–
[(F-4)T4], momentarily to start playback and con-
firmation.
y Push the selected memory channel, [(F-1)T1]–
[(F-4)T4], again to stop playback if desired.
u Push [EXIT] twice to exit voice memory screen.
•Programming a memory name for
transmit
Memory channels can be tagged with alphanumeric
names of up to 20 characters each.
Capital letters, small letters, numerals, some symbols
(! # $ % & ¥ ? " ' ` ^ + – ✱ /
.,
: ; = < > ( ) [ ] { } | _
_
)
and spaces can be used.
q Record a message as described above.
w Call up the voice memory recording screen as de-
scribed in step q to r above.
e Push [(F-5)NAME] to enter memory name edit
condition.
•A cursor appears and blinks.
r Push [(F-5)T1..T4] one or more times to select the
desired voice memory.
t Input the desired character by rotating the tuning
dial or by pushing the band key for number input.
•Push [ABC] or [abc] to toggle capital and small letters.
•Push [123] or [etc] to toggle numerals and symbols.
•Push [(F-1)Ω] or [(F-2)≈] for cursor movement.
•Push [(F-3)DEL] to delete the selected character.
•Push [(F-4)SPACE] to input a space.
y Push [EXIT] to input and set the name.
•The cursor disappears.
u Repeat steps r to y to program another voice
memory’s name, if desired.
i Push [EXIT] twice to exit voice memory screen.
To Next Page
Loading...
