72
9
SET MODE
■ Miscellaneous (others) set mode (continued)
CI-V baud rate
This item sets the data transfer rate. 300, 1200, 4800,
9600, 19200 bps and “AUTO” are available.
When “AUTO” is selected, the baud rate is automati-
cally set according to the connected controller or re-
mote controller.
AAUUTTOO
Auto baud rate
(default)
1199220000
19200 bps
CI-V address
To distinguish equipment, each CI-V transceiver has
its own Icom standard address in hexadecimal code.
The IC-756PRO’s address is 5Ch.
When 2 or more IC-756PRO’s are connected to an
optional CT-17
CI
-
V LEVEL CONVERTER
, rotate the tun-
ing dial to select a different address for each
IC-756PRO in the range 01h to 7Fh.
55CChh
Address of 5Ch
(default)
77FFhh
Address of 7Fh
CI-V transceive
Transceive operation is possible with the IC-756PRO
connected to other Icom HF transceivers or receivers.
When “ON” is selected, changing the frequency, op-
erating mode, etc. on the IC-756PRO automatically
changes those of connected transceivers (or re-
ceivers) and vice versa.
OONN
Transceive ON
(default)
OOFFFF
Transceive OFF
CI-V with IC-731
When connecting the IC-756PRO to the IC-735 for
transceive operation, you must change the operating
frequency data length to 4 bytes.
•This item must be set to “ON” only when operating trans-
ceiver with the IC-735.
OONN
4 bytes of frequency data
OOFFFF
5 bytes of frequency data
(default)
Mic Up/Down Speed
This item sets the rate at which frequencies are
scanned when the microphone [UP]/[DN] switches
are pushed and held. High or low can be selected.
HHIIGGHH
High speed (default,
50 tuning steps/sec.)
LLOOWW
Low speed
(25 tuning steps/sec.)
To Next Page
Loading...
