Icom IC-E2820 - Priority Watch Operation

80
9
PRIORITY WATCH
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Priority watch operation
qSelect VFO mode, then set an operating frequency in the
desired MAIN band
(left or right).
wSet the watched channel(s).
For memory channel watch:
Select the desired memory channel.
For memory scan watch:
Select memory mode; then, push and hold the main
band’s [V/MHz•SCAN] for 1 sec. to start memory scan.
For call channel watch:
Select the desired call channel by pushing the main band’s
[M/CALL•MW] once or twice, then rotate the [DIAL].
ePush and hold [LOW•PRIO] for 1 sec. to start the watch.
• The transceiver checks the memory or call channel every 5 sec.
• The watch resumes according to the selected scan resume con-
dition. (p. 77)
rPush and hold [LOW•PRIO] for 1 sec. to stop the watch.
z Select VFO mode; then, set the desired fre-
quency.
x Set the watched channel(s).
For memory channel watch:
Push [MR/CALL] then [Y] or [Z] to select the de-
sired memory channel.
For memory scan watch:
Push [MR/CALL], then push [
SCAN 2] to start the
memory scan.
For call channel watch:
Push [MR/CALL] for 1 sec. then push [Y] or [Z]
to select the call channel.
c Push [
PRIO 3(PTT-M)] to start the watch.
• The transceiver checks the memory or call channel
every 5 sec.
• The watch resumes according to the selected scan re-
sume condition. (p. 77)
•To resume the watch manually when paused, push
[ PRIO 3(PTT-M)].
v To stop the watch, push [
CLR A(MW)].
PRIO
3