Icom IC-E2820 - Programming Memory;Bank;Scan Name

65
6
MEMORY MODE OPERATION
■ Programming memory/bank/scan name
Each memory channel can be programmed with an alphanu-
meric channel name for easy recognition and can be indi-
cated independently by channel. Names can be a maximum
of 8 characters— see the following table for available char-
acters.
qSelect the desired memory channel to be programmed.
➥ Push [M/CALL•MW] several times to select memory
mode, then rotate the same band’s [DIAL] to select the
desired memory channel.
wPush and hold the same band’s [M/CALL•MW] for 1 sec.
to enter select memory write mode.
•“X” indicator and the memory channel number blink.
ePush [SEL](V/MHz•SCAN) (Left band’s) several times to se-
lect programming the name conditions.
“BANK” : The memory bank
“B NAME” : The bank name
(appears only when the selected
memory bank is edited into a bank)
“M NAME” : The memory name
“S NAME” : The scan name
(appears only when a scan edge
channel is selected)
• Frequency readouts disappear.
rPush [EDIT](M/CALL•MW) (Right band’s) to edit.
•“X” indicator and cursor blinks.
tRotate the same band’s [DIAL] to select the desired char-
acter.
• The selected character blinks.
• Push [Aa](TONE•DTMF) to select the character group from cap-
ital letter characters or lower case letters.
• Push [1/](M/CALL•MW)
(Right band’s) to select the character
group from numbers or symbols.
• Push [>](M/CALL•MW) (Left band’s) to move the cursor right;
push [<](V/MHz•SCAN) (Left band’s) to move the cursor left.
• Push [CLR](DUP/MONI) to clear the selected character.
• Push and hold [CLR](DUP/MONI) for 1 sec. to clear all charac-
ters after the selected character.
yRepeat steps e and t until the desired channel name is
programmed.
uPush [BACK](V/MHz•SCAN)
(Right band’s) to set the name.
iPush and hold [S.MW](M/CALL•MW)
(Right band’s) for
1 sec. to overwrite the memory channel to store the mem-
ory name.
NOTE: Only one bank name can be programmed into
each bank. Therefore, the previously programmed bank
name will be displayed when bank name indication is se-
lected. Also, the programmed bank name is assigned for
the other bank channels automatically.
DD
Available characters
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
(Space)! ''#$%&'()*+,-
./:;<=>?@[\]^_`{|}
~