Icom IC-E2820 - Page 87

66
6
MEMORY MODE OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
[EXAMPLE]: Programming the bank name “AIR” into the scan edge channel 3A.
Enter “I” and “R” with (Main
band’s) and (Left band’s), then
push (Right band’s) to select
memory write mode.
V/MHz
SCAN
M/CALL
MW
Push and hold (Left band’s) for 1 sec. to program.
M/CALL
MW
Push (Main band’s) to select memory mode.
Rotate (Main band’s) to
select “A”, then push .
M/CALL
MW
Push and hold (Main band’s) for 1 sec.
to enter select memory write condition.
Push (Main band’s) several times
to select “B NAME”.
Push (Right band’s) to enter bank
name edit mode.
*Select “M NAME” or “S NAME” when programing the memory name or the
scan name, respectively.
Bank name edit mode
Select memory write mode
Memory mode
SEL
EDIT
M/CALL
MW
>
Rotate (Main band’s) to select scan edge
channel 3A.
M
A
I
N
B
A
N
D
M
A
I
N
B
A
N
D
M
A
I
N
B
A
N
D
M/CALL
MW
>
V/MHz
SCAN
BACK
M/CALL
MW
S.MW
DD
To indicate the channel name
The channel name indication can be set independently for
each memory channel.
qSelect the desired memory channel in the main band.
➥ Push the same band’s [M/CALL•MW] several times to
select memory mode, then rotate the same band’s [DIAL]
to select the desired memory channel.
•“X” and memory channel number appear.
wPush [F•]to display the function guide.
ePush [M.N](LOW•PRIO) several times to select “MEMORY
NAME,” “FREQUENCY” or OFF.
• When “MEMORY NAME” is selected, the programmed memory
name is indicated above frequency indication; when “FRE-
QUENCY” is selected, the programmed memory name is indi-
cated at the frequency indication and the programmed frequency
is indicated above the memory name.
rPush [F•]twice to exit the function guide indication.
NOTE: When no memory name is programmed, the stored
frequency is displayed.