Icom IC-E2820 - Erasing;Transferring Bank Contents; Memory Mode Operation

70
6
MEMORY MODE OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
Contents of programmed memory banks can be cleared or
transferred to another bank.
INFORMATION: Even if the memory bank contents are
cleared, the memory channel contents still remain pro-
grammed.
qSelect the desired bank contents to be transferred or
erased from the band
(left or right).
➥ Push the desired band’s [M/CALL•MW] several times
to select memory mode.
➥ Push and hold the same band’s [MAIN•BAND] for
1 sec. then rotate the same band’s [DIAL] to select the
desired memory bank.
➥ Push the [MAIN•BAND] to select the bank then rotate
the [DIAL] to select the desired bank channel.
• Bank initial and bank channel stops blinking.
wPush and hold the same band’s [M/CALL•MW] for 1 sec.
•“X” indicator and the memory channel number blink
ePush [SEL](V/MHz•SCAN) (Left band’s) several times to se-
lect BANK, then push [EDIT](M/CALL•MW)
(Right band’s).
rRotate [DIAL] to select the desired bank initial
(A to Z) to
transfer.
• Select no indication, “– – – –,” when erasing the contents from
the bank.
tPush [>](M/CALL•MW) (Left band’s) then rotate the same
band’s [DIAL] to select a bank channel, if desired.
yPush [BACK](V/MHz•SCAN)
(Right band’s) to return to the
select memory write mode.
uPush and hold [S.MW](M/CALL•MW)
(Left band’s) for 1 sec.
to be transferred or erased.
iRepeat steps q to t for transferring or erasing an another
bank’s contents.
■ Erasing/transferring bank contents