III
QUICK REFERENCE GUIDE
D Controller/Separation cable connection
Two connection cables, controller cable (10 cm) for single
body installation and separation cable
(3.4 m) for remote in-
stallation, are supplied with the IC-E2820.
Connect the controller and the main unit using with the sup-
plied connection cable as follows.
IMPORTANT!— number of pin
The connectors on the ends of the connection cable have dif-
ferent numbers of pins - one end has 6 pins and the other end
4 pins. You should connect the 6-pin connector to the main
unit, and the 4-pin connector to the controller.
D Microphone connection
A microphone connector is available on the main unit front
panel. Connect the supplied microphone connector as illus-
trated below.
Attach the supplied microphone connector plate after the mi-
crophone connection, otherwise the controller will separate
from the mail unit when the microphone cable is pulled during
single body installation.
To Next Page
Loading...
