Icom IC-E2820 - Digital Repeater Operation

42
5
DV MODE OPERATION (Optional UT-123 is required)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Digital repeater operation
Repeater call signs must be programmed for repeater opera-
tion in both digital voice and low-speed data communications.
DD
Repeater call sign programming
qPush [F•]to display the function guide.
wPush [MENU](V/MHz•SCAN)
(Right band’s) to enter MENU
screen.
eRotate [DIAL] to select “CALL SIGN MEMORY” then push
[MAIN•BAND].
rRotate [DIAL] to select “RPT CALL SIGN MEMORY” then
push [MAIN•BAND].
tRotate [DIAL] to select the desired call sign channel
(R01 to
R60), then push [MAIN•BAND].
yRotate [DIAL] to select the desired character, then push
[>](M/CALL•MW)
(Left band’s) to move the cursor right.
• Push [<](V/MHz•SCAN) (Left band’s) to move the cursor left.
• Push [ABC](TONE•DTMF) to select the character group from
capital letter characters.
• Push [12/](M/CALL•MW) (Right band’s) to select the character
group from numbers or symbols.
• Push [CLR](DUP•MONI) to clear the selected character.
• Push [GW](LOW•PRIO) to turn the gateway setting ON/OFF.
uRepeat step y until repeater call sign is programmed.
iPush [MAIN•BAND] to store the programmed call sign.
oPush [BACK](V/MHz•SCAN)
(Right band’s) three times to
return to frequency indication.