Icom IC-E2820 - Page 49

28
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
DD
Single sweep
qSet the desired frequency as band scope center frequency.
wPush [F•]to display the function guide.
ePush [SCP](DUP•MONI) to start a single sweep.
•1 short beep sounds.
• Signal strengths appear starting from the lower edge of the
range.
rRotate [DIAL] to set the frequency marker to the desired
signal and set the frequency of the signal.
tPush [F•]to display the function guide, then push
[CLR](LOW•PRIO) to clear the band scope.
DD
Continuous sweep
qSet the desired frequency as band scope center frequency.
wPush [F•]to display the function guide.
ePush and hold [SCP](DUP•MONI) for 1 sec. to start con-
tinuous sweep.
•1 short and 1 long beeps sound.
• Signal strengths appear starting from the center of the range.
rTo stop sweeping, push [F•]to display the function
guide, then push [SCP](DUP•MONI).
tPush [F•]to display the function guide, then push
[CLR](LOW•PRIO) to clear the band scope.
The receive audio during sweeping can be muted in
sounds set mode. See page 109 for details.
DD
Monitoring a signal
If you find a signal that you want to monitor during/after
sweep, you can monitor the signal with the following opera-
tion.
qPush [F•]to display the function guide, then push
[SCP](DUP•MONI) to cancel the continuous sweep, if nec-
essary.
wRotate [DIAL] to tune into the desired signal.
ePush [CENT](TONE•DTMF) to return to the center fre-
quency.