18
3
D Receiving a Stun or Revive
If a Stun command is received that matches your station ID,
the transceiver will display “SORRY” (
Simple and 10-key types
only) and you can not receive or transmit. When a Revive
command is received that matches your station ID, normal
operation is restored.
D Receiving a Radio Check or Status Polling
If a Radio Check or Status polling command that matches
your station ID, the transceiver will transmit automatically.
➥ When a Radio Check command is received;
• The transceiver automatically transmits the acknowledgement
call.
➥ When a Status Polling command is received;
• The transceiver automatically transmits the status call. (Simple
and 10-key types only)
D Call log function
Not available on Non-display types.
After receiving a SelCall, Call Alert or Emergency call, the
call log is displayed (depends on the setting.) Up to 5 logs
can be memorized, and the oldest log is erased when the 6th
call is received.
q Push [MDC CALL] to enter the MDC menu selection mode.
w Push [CH Up] or [CH Down], or rotate [CH Up/Down] to
select “CALL LOG.”
e Push [MDC] again to display a call log.
• When no call is received, an error beep sounds.
For Handhelds: For Mobiles:
r Push [CH Up] or [CH Down] to select a desired one.
NOTE: If 1000 hours has passed after receiving the call,
the elapsed time will be reset to 0:00.
MDC 1200 SYSTEM OPERATION
3
ID 1234
SC - 0:27
MDC SELC CALA
ID 12343
SCT - UNK0:27
Elapsed time from
receiving the call
: SelCall
: Call Alert
: Emergency call
Call type
SC
CA
EMG
1
2
4
5
6
7
8
9
10
12
11
13
14
15
16
To Next Page
Loading...
Need help?
General
