41
4
APCO P25 MODE OPERATION
n Remote Monitor function
D Transmitting
A Remote Monitor function allows you to send a signal that
requires the target station to transmit audio from the micro-
phone, or from the external unit connected to the D-sub 25-
pin
connector (for Mobile transceivers only)
.
[Digital Button] key assignment is necessary to transmit the
remote monitor signal.
Not available on Non-display types.
q Push [Digital Button] to enter the digital call type selec-
tion mode.
w Push [CH Up] or [CH Down], or rotate [CH Up/Down] to
select “RDO MONITOR.”
For Handhelds: For Mobiles:
RDO MONITOR
DSEL PAGE STAT
RDOMONITOR
e Push [Digital Button] again to enter the Individual ID se-
lection mode.
• A preset ID name is displayed.
• When the ID name is not programmed, the ID code is displayed.
For Handhelds: For Mobiles:
RDO MONITOR
INDIVIDUAL1
DSEL PAGE STAT
RDOMONITOR
INDIVIDUAL1
r Push [CH Up] or [CH Down], or rotate [CH Up/Down] to
select a desired ID (or name).
• Hold down [Digital Button] for 1 second to cancel and return to
normal operation.
• The ID can be edited with the 10-keypad, depending on the
presetting. (10-key types only) See page 32 for editing details.
To Next Page
Loading...
Need help?
General
