33
4
APCO P25 MODE OPERATION
n Talkgroup call
D Transmitting
A Talkgroup call allows you to make a call to a specific group
only.
[Talkgroup] key assignment is necessary to transmit the
Talkgroup call.
Not available on Non-display types.
✔ For Trunking mode operation:
The [Talkgroup] key is not usable while in the Trunking mode.
To make a Talkgroup call, the group affiliation should be per
-
formed with the desired Talkgroup ID to call.
q Push [Talkgroup] to enter the Talkgroup ID (or name) se-
lection mode.
• “TGID” inverts to “
TGID
.” (for Handhelds)
• The key indicator appears above the key to which [Talkgroup] is
assigned. (for Mobiles)
• A preset ID name is displayed.
• When the ID name is not programmed, the ID code is dis-
played.
• Push again to cancel and return to normal operation.
For Handhelds: For Mobiles:
TG:1
INDV TGID SET
TGID
TG:1
w Select a desired Talkgroup ID (or name) using [CH Up]/
[CH Down], or [CH Up/Down].
NOTE: When ‘65535’ is selected as the Talkgroup ID,
All Call is an open call to everyone on your system.
e Hold down [PTT] to transmit the Talkgroup call to the spe-
cific group, then speak into the microphone.
• The LED indicator
(for Handhelds) or Transmit indicator (for Mo-
biles) lights red.
• Depending on the presetting, the target station does not open
the squelch, and communication is not established, if the Talk-
group ID or NAC (Network Access Code) is not matched.
• The Talkgroup ID (or name) is displayed for 2 seconds when
[PTT] is pushed. (Depending on the presetting.)
r Release [PTT] to receive.
To Next Page
Loading...
Need help?
General
