27
4
APCO P25 MODE OPERATION
n Control Channel Hunt function (P25 Trunking mode only)
(Continued)
If the control channel is found, the transceiver attempts regis-
tration and group affiliation.
• “Registering” is displayed while registering.
(Simple and 10-key
types only)
• “Affiliating” is displayed while group affiliating.
(Simple and 10-key
types only)
For Handhelds: For Mobiles:
ch-03
D-TRUNK 03
ch-03
D-T R UNK 03
Blinks when registration and group affiliation
are performed. (Simple and 10-key types only)
✔ FAILED:
The transceiver will continue to hunt for the next site.
If a control channel is not found, the transceiver may start the
Control Channel Band Scan, depending on the presetting.
See page 28 for details.
✔ SUCCEEDED:
The transceiver can be operated in the P25 Trunking system.
For Handhelds: For Mobiles:
ch-03
D-TRUNK 03
ch-03
D-T R UNK 03
Appears after registration and group affiliation
are successful. (Simple and 10-key types only)
NOTE: “NO COMM” message is displayed, as illustrated
below, when the group affiliation has failed (Simple and 10-
key types only). In that case, change the operating channel
or turn power OFF then ON again to retry hunting.
For Handhelds: For Mobiles:
ch-03
NO COMM
ch-03
NO C OMM
To Next Page
Loading...
Need help?
General
