Icom IC-M323 - Page 63

53
7
DSC OPERATION
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
[Example]: Receiving a Distress Relay call.
When a Distress Relay call is received:
The emergency alarm sounds for 2 minutes. ➥
“RCVD DISTRESS RELAY” is displayed and the backlight ➥
blinks.
[IGN]
Push to return to the normal operating mode. ➥
  •ThetransceiverexitstheDSCmode.
  •Bypushing[PTT],thetransceiveralsoexitstheDSCmode.
  •“ ” continues to blink and the Call is stored in the Received
Call Log.
Push [ALARM OFF] to q
stop the alarm and the
blinking backlight.
 •Even if you do not push
[ALARM OFF], the alarm
stops after 2 minutes, and
then the screen in step w
is displayed.
Push a softkey to select w
your desired action.
D Receiving a Distress Relay Call/Distress Relay Acknowledgement
[INFO]
Push to display the Re- ➥
ceived call information.
(p. 60)
[ACPT]
Push to accept the call. ➥
And then, push [CH 16]
to change the operating
channel to Channel 16,
and then monitor it, as a
coast station may require
assistance.
 •Evenifyouhaven’tpushed
[CH 16] within 10 seconds,
the operating channel au-
tomatically changes to
Channel 16. (p. 63)
Push