Icom IC-M330GE

50
8
MENUSCREEN
New2001
GPS
SelectsasatellitetobeusedforGPS(GlobalPositioning
System) to pinpoint the geographic location of your
transceiver anywhere in the world.
L This setting may not be usable, depending on the transceiver
version or presetting.
• GPS (AlwaysOn)
TheGPS(GlobalPositioningSystem)ispermanentlyset
to ON.
• GLONASS (Default:On)
SelectswhetherornottousethedatafromtheGLONASS
(GLObal'nayaNAvigatsionnayaSputnikovayaSistema)
satellites.
• SBAS (Default:Off)
TurnstheSBAS(SatelliteBasedAugmentationSystem)
functionONorOFF.
TheSBAStransmitssignalstocorrecterrors,and
improves accuracy and reliability in data received from
regularGNSSsatellites.WhenthisfunctionisON,youcan
use the corrected data.
D Radio Settings
Scan Type (Default:—)
The transceiver has 2 scan types. Select Normal Scan and
Priority Scan.
NormalScan:ScansallFavoritechannelsintheselected
channel group.
PriorityScan:SequentiallyscansallFavoritechannels,
whilemonitoringChannel16.
L The default setting differs, depending on the transceiver version.
Scan Timer (Default:Off)
YoucanusetheScanTimertopause,ortoresumeafter5
seconds, when a signal is detected.
On: When a signal is detected on a channel, the scan
pausesfor5seconds,andthenresumes.Ifthe
signal disappears in less than 5 seconds, the scan
immediately resumes.
Off: When a signal is detected on a channel, the scan
pauses until the signal disappears, and then resumes.
Dual/Tri-watch (Default:Dualwatch)
SelectDualwatchorTri-watch.
Dualwatch: MonitorsChannel16whilereceivingon
another channel.
Tri-watch: MonitorsChannel16andtheCallchannel
while receiving on another channel.
L See page 17 for details.