15
6
SCAN OPERATION
6
■ Favorite channels
You can quickly recall often-used channels by setting them as Favorite
channels. You can set Favorite channels in each Channel Group.
D Setting/Clearing
1. Push [▲] or [▼] to select the channel.
2. Hold down [FAV] for 1 second to set or clear as a Favorite
channel.
• The selected channel is set as a Favorite channel, and “ ” is
displayed.
D Selecting
z Push [FAV].
L Non-Favorite channels are skipped and not displayed.
TIP: You can clear all Favorite channels.
L If there is no Favorite channel, all channels will be set as Favorite
channels.
1. Turn OFF the transceiver.
2. While holding down [FAV], turn ON the transceiver.
■ Starting a scan
(Except the HOL version)
Example: Starting a Normal Scan.
1. Push [SCAN] to start the scan.
• “SCAN” blinks during a Normal Scan.
• “
” is also displayed during a Priority Scan.
• “
” is displayed when a signal is received.
L When a signal is received, the scan pauses until it disappears,
or resumes after 5 seconds, depending on the Set mode
setting. (p. 18)
L 2 beeps sound and “
” blinks when a signal is received on
Channel 16 during a Priority scan.
2. Push [SCAN] to stop the scan.
TIP: In order to properly receive signals, be sure to adjust the squelch
to a suitable level.
To Next Page
Loading...
