Icom IC-M37 - Set Mode Items

18
8
SET MODE
■ Set mode items
NOTE: The Set mode items contained in
the transceiver may be different, depending
on the transceiver’s version or presettings.
Ask your dealer for details.
Beep “ ”
Turns the Key Beep function ON or OFF.
OFF: Turns OFF the function for silent
operation.
ON:
When a key is pushed, a beep sounds.
WX Alert “ ”
(For the USA, EXP, and AUS versions)
Turns the Weather Alert function ON or OFF.
L See page 10 for details.
OFF: The transceiver does not detect a
Weather Alert tone.
ON: The transceiver detects the Weather
Alert tone, and the “
” icon
blinks and a beep sounds.
L The blinking stops when another
key is pushed.
Scan Type “ ”
(Except the HOL version)
Turns the Priority Scan function ON or OFF.
OFF: The scan type is set to “Normal,” which
sequentially searches all Favorite
channels in the channel group.
ON: The scan type is set to “Priority,”
which sequentially searches all
Favorite channels in the channel
group, while also periodically checking
Channel 16 (Priority channel).
Scan Timer “ ”
(Except the HOL version)
Turns the Scan Resume Timer ON or OFF.
OFF:
When a signal is detected on a
channel, the scan pauses until the
signal disappears, and then resumes.
ON: When a signal is detected on a channel,
the scan pauses for 5 seconds, and
then resumes. If the signal disappears
in less than 5 seconds, the scan
immediately resumes.
Auto Scan “ ”
(Except the HOL version)
Turns the Automatic Scan function ON or OFF.
OFF: The function is OFF.
ON: Scan automatically starts when no
signal is received, or no operations
are carried out for 30 seconds.
Dual/Tri-watch “ ”
(Except the HOL version)
Selects Dualwatch or Tri-watch.
d- (Dual):
Periodically checks Channel 16
while operating on another channel.
t- (Tri): Periodically checks Channel
16 and the Call channel while
operating on another channel.
SQL Key Action “ ”
The function temporarily opens the squelch.
Pu (Push): The Monitor function is activated
by holding down [VOL/SQL] for
more than 1 second. The squelch
opens while holding down the key.
Ho (Hold): The Monitor function is activated
by holding down [VOL/SQL]
for more than 1 second.
The
squelch stays open until the
user pushes any key.
Backlight “ ”
Turns the Automatic Backlight function ON
or OFF.
OFF: The function is OFF.
ON:
The backlight turns ON for 5 seconds
when the user pushes any key
except [PTT].
Contrast “ ”
Selects the transceiver’s display contrast.
Hi: The transceiver’s display contrast is set
to High.
Lo: The transceiver’s display contrast is set
to Low.
Power Save “ ”
Turns the Power Save function ON or OFF.
OFF: The function is OFF.
ON: The Power Save function reduces
current drain by deactivating the
receiver circuit of the transceiver at
specied intervals.