16
DUALWATCH/TRI-WATCH
New2001New2001
6
■ Description
Dualwatch monitors Channel 16 while you are receiving
another channel; tri-watch monitors Channel 16 and the call
channel while receiving another channel.
■ Operation
q Select the desired operating channel.
w Push [SCAN•DUAL] for 1 sec. to start dualwatch or tri-
watch
(depending on the SET mode setting; p. 19)
.
•“DUAL” blinks during dualwatch; “TRI” blinks during tri-watch.
• A beep tone sounds when a signal is received on Channel 16.
• Tri-watch becomes dualwatch when receiving a signal on the call
channel.
e To cancel dualwatch/tri-watch, push [SCAN•DUAL] again.
DUALWATCH/TRI-WATCH SIMULATION
• If a signal is received on Channel 16, dualwatch/tri-watch
pauses on Channel 16 until the signal disappears.
• If a signal is received on the call channel during tri-watch,
tri-watch becomes dualwatch until the signal disappears.
• To transmit on the selected channel during dualwatch/tri-
watch, push and hold [PTT].
Dualwatch Tri-watch
Call channel
[Example]: Operating tri-watch on INT channel 07.
Signal is received
on the call channel.
A signal receive on
Channel 16 always
takes priority.
Tri-watch resumes
after the signal
disappears.
Tri-watch starts.
Push for 1 sec.
IC-M72_1.qxd 06.1.11 18:19 Page 16 (1,1)
To Next Page
Loading...
