Icom IC-M72

32
SPECIFICATIONS
New2001New2001
13
DD
GENERAL
• Frequency coverage : TX 156.025–157.425 MHz
RX 156.050–163.275 MHz
• Mode : 16K0G3E
• Power supply requirement : Specified Icom’s battery pack only
• Current drain (at 7.5 V DC; approx.):
TX High (at 6 W)
1.7 A
TX Mid.
(at 3 W) 1.3 A
TX Low (at 1 W) 0.7 A
RX Max. audio 400 mA (internal speaker)
200 mA (external speaker)
• Useable temperature range : –20°C to +60°C; –4°F to +140°F
• Frequency error : ±10 ppm
• Antenna connector : SMA (50 Ω nominal)
• Dimensions : 52.5(W) × 125(H) × 30(D) mm
(Projections not included) 2
1
⁄16(W) × 4
29
⁄32(H) × 1
3
⁄16(D) inch
• Weight (with BP-245) : Approx. 280 g (9.9 oz)
DD
TRANSMITTER
• Output power (at 7.5 V DC) : 6 W* (High), 3 W (Middle)
and 1 W (Low) *5 W for some versions
• Modulation system : Variable reactance frequency mod-
ulation
• Max. frequency deviation : ±5 kHz
• Adjacent channel power : 70 dB
• Spurious emissions : –68 dBc typical
DD
RECEIVER
• Receive system : Double-conversion superhetero-
dyne
• Sensitivity (12 dB SINAD) : 0.22 µV typical
• Squelch sensitivity : 0.35 µV typical
(at threshold)
• Intermodulation rejection ratio: 70 dB typical
• Spurious response rejection ratio:
70 dB typical
• Adjacent channel selectivity : 70 dB typical
• Audio output power :
Internal speaker 0.6 W typical at 10% distortion with an
8 Ω load
External speaker 0.35 W typical at 10% distortion with an
8 Ω load
All stated specifications are subject to change without notice or
obligation.
IC-M72_1.qxd 06.1.11 18:20 Page 32 (1,1)