IDEAL TILT-A WAY HYJG 1

71
 If service reminder on or after date is Enabled then the date can be
set here “08/21/2021”
o Test relays
 Relay Test / Latch“no latched relays / latch relay K1 / latch relay
K2 / latch relay K3 / latch relay K4 / latch relay K5”
o Factory config. This submenu is for factory use only.
 Caution! Apply volts and trim calibration “24.0 volts”
 Caution! Zero life time cycle counter “no / yes”
 Caution! Reset all settings to defaults “no / yes”
 Statistics
o Gate Cycle Count
 Total gate life time cycle count (000000)
 Cycle count since last service reset (00000)
o Motor board #1 bus. This submenu is factory use only.
o Motor board #2 bus. This submenu is factory use only.
 Event Logs
o General Event Log
 Event #1 (most recent)
o Safety Event Log
 Event #1 (most recent)