Battery monitoring timeout : 00:05:00
Next Battery monitoring :
Battery coefficient : 9.37e-05
Battery working limit [V]: 3.2
Test external power ?: Yes
Ext power coefficient (OFS): 3.7153001
Ext power coefficient (SLP): 0.00041919999
Ext power working limit [V]: 9
Optical sensors auto-scale settling time [ms]:800
Unattended cycles,PRESSURE auto-zero ?:No
Ana.board filtering [0..5]: 2
16bit ADC reading method:0,1,2: 1
16bit ADC filter:0)None,1)Average,2)LowPass: 2
Lowpass factor x^2: 2
24bit ADC filter:0)None,1)Average,2)LowPass,3)IIRFilter: 2
Smoothing factor: 0.8
Activate the EXTERNAL sensor power ?:No
ZebraTech HydroWiper installed ?:No
Wait EXTERNAL power stabilization [ms]:300
Wait EXTERNAL sensor startup [ms]:100
Wait ANALOG Board replay [ms]:1200
D.2 AUXILIARY SENSOR PARAMETERS
By means of the <CNES> configuration command, available under the Configuration Menu, it is
possible to modify the below listed parameters:
--- Auxiliary setup ---
Aux.#1,select:(0)None,(1)Trilux,(2)Wetlab ECO
Aux.#1:0
Aux.#2-Rosette:(0)No,(1)GO1018,(2)SBE32c,(3)MISS
Aux.#2:0
WARNING
Please,manually delete unused sensors from the sensor configuration
Aux.#3 Select:(0)None,(1)miniSVS,(2)BlueCap-DO2
Aux.#3:0
Please,manually delete unused sensors from the sensor configuration
To Next Page
Loading...
