F.5 START-UP SWITCHES
It is possible to customize the programme at the start-up by adding the following switches to the
programme properties:
- p x Where “x” represents the communication port number 1..8.
- b bps Where “bps” represents the communication speed and can be 1200, 2400, 4800, 9600, 19200,
38400, 57600, 115200.
F.6 TROUBLESHOOTING
The automatically generated files “Detect.log” and “Upgrade.Log” contain the dialog between the
programme and the probe concerning the operations of probe detection and probe upgrading. In case
of trouble, please send us the above files together with a short description of the problem.
F.7 PROGRAMMES DISTRIBUTED WITH THE ITERM SOFTWARE
The following programmes are distributed with the ITERM software:
❖ Interpolate.
❖ OS3xx Probe Memory & Battery Autonomy.
❖ Water Properties calculator.
❖ Ocean Seven 3xx calibration.
Note
The Ocean Seven Probe Memory & Battery Autonomy calculator is described in the maintenance section.
F.7.1 Interpolate
This program allows calculating the “a” and “b” coefficients (slope and offset) to interpolate a set of 10
tabbed data (see picture) using: linear, logarithmic or exponential interpolation technique.
F.7.2 Sea Water Fundamental property calculation
This tool allows the probe to calculate the most important fundamental properties of seawater. Through
a very simple interface, the operator can enter the Temperature, Conductivity and Pressure sensor
values and calculate the derived parameters instantaneously. Calculation is performed using the
UNESCO formulae and recommendations.
To Next Page
Loading...
