IDTECH VP6800 - Other Status Messages

ID TECH VP6800 User Manual
Page | 15
6.4.1. Other Status Messages
The VP6800’s LCD can display the following messages for both regular status and in the event of a
failed self-check:
State
Buzzer
LCD
Indicating
Tamper
triggered
Beeps
every 1
second
"Tampered”
Device was tampered by physical, temperature, or voltage
attack. All sensitive information is erased or unrecoverable.
The reader blocks all sensitive functions. There is no way to
recover the reader except to return it to ID TECH.
Certification
check fail
No sound
"Cert Fail"
Certificate tree self-check has failed (example of failure:
expiration of certification).
Firmware
integrity
check fail
No sound
"MSRFail"
MSR failure, usually caused by the abnormal state of the
MSR module.
No sound
"FW/BL Fail"
Firmware self-check has failed
Abnormal Key
Status
No sound
"Keys Fail"
Encryption key self-check has failed.
No sound
“Need More
Key”
“Self –test Fail”
The reader is activated but not ready for sensitive
functions. The reason is most likely due to missing working
keys, the reader being suspended due to self-test failure,
sensitive limitation, or similar causes.
Deactivated
Short
beep for 5
seconds
"Deactivated"
The reader is in “Manufactory mode;” no security functions
are enabled.
Activated
No sound
"Activated"
Manufactory data and certificate are loaded into the reader,
but no working keys.
Ready
No sound
"Welcome"
The reader is ready for sensitive functions like transactions,
Get PIN ,GET account, and similar commands.
If your VP6800 is tampered, contact ID TECH support
for assistance.