IDTECH VP6800 - Setting the Device IP; Setting the Remote IP

ID TECH VP6800 User Manual
Page | 26
8.2.1. Setting the Device IP
1. To set the Device IP, enter IP address information in the field highlighted in blue.
a. Select Next to move to the next field.
b. Select Enter after completing the configuration to save.
c. To clear a field, select Cancel.
d. To exit the menu without making changes, select Cancel again.
2. The VP6800’s screen displays an IP is Set dialog on success.
8.2.2. Setting the Remote IP
1. To set the Remote IP, enter IP address information in the field highlighted in blue.
ID TECH’s Encryption protocol port is 1443; make sure to enter that number as the port.
a. Select Next to move to the next field.
b. Select Enter after completing the configuration to save.