GB
6 - USE AND OPERATION MASTER 880MP E-volution
6 - Pag. 16 / 17
6.9 LUBRICATION OIL - FLOW ADJUSTMENT
Oil flow in the guides and bush-
holder device is automatically
controlled during the feeder
automatic cycle. The pump is
started after the feeder has
completed bar change-over; it is
stopped when the bar-pusher
approaches the bush-holder device.
It is necessary to adjust the oil flow
in the bushing-holding device
according to the bar diameter and
profile.
6.10 BAR FEEDER STOP
BAR FEEDER EMERGENCY STOP
CAUTION:
if the emergency stop is enabled during the lathe machining, before starting the
working cycle again, make sure that no dangerous condition due to the sudden
stop has occurred. Example: if the tool was removing chip, take the piece far
from the lathe before starting the lathe again.
• To stop the bar feeder in the emergency status, press one of the emergency push-buttons of
the bar feeder or the lathe.
BAR FEEDER STOP AT MACHINING END
CAUTION:
do not use the emergency push-buttons for the ordinary bar feeder stop.
• Achieve the operations of the working program.
• Stop the bar feeder pressing push-button
.
• Stop the lathe.
• Turn the main electric switch onto position OFF.
To Next Page
Loading...
