EN
2 - TECHNICAL INFORMATION VIP80E-II
2 - Pag. 6 / 28
2.2 OPERATING CYCLE
The phases of the bar feeder
operating cycle are represented and
described below.
- At the stop of the lathe working
cycle, the bar pusher (A) moves
to the back limit stop position.
- The bar pusher (A) is lifted.
- At the same time, the guide
channel/magazine (B) is lifted
and the bar selection table (C)
is lowered (the bars before the
bar which is to be loaded are
blocked).
- The "bar drop control device"
unit (D) is lowered and
accompanies the first bar into
the guide channel (E). The bar is
already in line with the loading
axis.
8070_02_03_1
A
8070_02_15_1
A
B
C
D
E
8070_02_16_1
To Next Page