4 - MOVEMENT AND INSTALLATION VIP80E-II
EN
4 - Pag. 17 / 22
4.9 ELECTRIC CONNECTION
INFORMATION:
the connections to the power supply must be carried out following the
indications on the wiring diagram provided by the manufacturer.
The person who is authorized to carry out this operation, shall have special skills and
experience acquired and recognized in the specific area. He shall carry out the connection to
the power supply workmanlike, taking into account all regulative and law requirements, not only
concerning the bar feeder but also the connection to the lathe.
When the connection to the power supply is completed, before starting the bar feeder, inspect
if the above-mentioned requirements have been fulfilled.
Connect the multipolar connector provided with the bar feeder to the lathe socket.
To Next Page