EN
5 - ADJUSTMENTS AND SETUP VIP80E-II
5 - Pag. 4 / 8
Parameter setting
Once the mechanical adjustments have been completed, it is necessary to modify the following
parameters using the push-button panel.
- enter value 2 in the "Bar Type" parameter 16
- enter the value of the bar size in the "Bar Size" parameter 8.
INFORMATION:
For further information on the modification methods of parameters, refer to the
"Instruction manual" which you can find attached.
INFORMATION:
Once the machining of hexagonal bars has finished, it is ABSOLUTELY
NECESSARY to reposition the magazine in its normal working condition (less
steep slope).
To carry out this adjustment refer to the previous procedure taking care, when
removing the screws (A), to move the lever (B) slowly backwards until the
correct positioning of the magazine.
To Next Page