IEMCA VIP80E-II - Revolving Tip Check

7 - BAR FEEDER MAINTENANCE VIP80E-II
EN
7 - Pag. 3 / 6
7.2.1 Air filter unit - Check
FILTER A
• Check that the cup (A) does not contain
condensation. If necessary, bleed by turning
knob (C).
• Check pressure switch adjustment, see paragraph
5.2.
7.3 REVOLVING TIP CHECK
For checking proceed as follows:
- Disassemble the bar pusher, (see paragraph 6.8).
- Check that the push-rod (A) and the bearings (B)
of the unit move freely and without any excessive
play.
- If necessary, replace the revolving tip (see
paragraph 9.2).
- Install the bar pusher again.
8070_07_02_1
A
B
B
A
8070_07_01_1