24
Connector holster installation
The storage means provided for the vehicle connector shall be located at a height between 50cm and 150cm
above ground level.
I WARNING
HAZARD OF ELECTRIC SHOCK OR DAMAGE TO THE CHARGING STATION
• Do not use this product if the cables (input or output) are frayed, have damaged insulation
or any other signs of damage.
• A cord extension set or second cable assembly or adaptator must not be used in addition
to the coupler/cable assembly for the connection into the vehicle.
Failure to follow these instructions will result in death or serious injury.
1. Using bracket as a template, level and mark drill
holes
2. Place the anchors and attach the bracket to the
wall with screws (8) - position 1
Note: Fasteners should be countersunk head type
concrete screws or sleeve anchors, 6mm with a mini-
mum length of 50mm
1
Connector’s holster installation
1
To Next Page
