IFM AL1940 - Lr Device

23
ifm Device Manual IO-Link Master with Modbus interface CabinetLine 8 Ports IP 20 (AL1940) 05 / 2018
Configuration LR DEVICE
>
8.1 LR DEVICE
Remarks .................................................................................................................................................24
IoT: Configure access rights ...................................................................................................................25
IoT: Configure IP settings .......................................................................................................................26
IoT: Configure the interface to the LR SMARTOBSERVER ..................................................................27
Fieldbus: configure Modbus port ............................................................................................................28
IO-Link ports: Activate data transfer to the LR SMARTOBSERVER .....................................................29
IO-Link ports: Configure operating mode ...............................................................................................30
IO-Link ports: Set the device validation and data storage ......................................................................31
IO-Link ports: set fail-safe values ...........................................................................................................32
Info: Show device information ................................................................................................................32
Firmware: Reset device to factory settings ............................................................................................33
Firmware: Reboot the device..................................................................................................................33
Configure IO-Link devices ......................................................................................................................34
22822
On delivery, the AL1940 is configured with the factory settings (→ Factory settings (→ p. 64)).
Required software: LR DEVICE (1.3.1.x or higher) (art.-no.: QA0011/QA0012)