IFM AL1940 - Page 3

3
ifm Device Manual IO-Link Master with Modbus interface CabinetLine 8 Ports IP 20 (AL1940) 05 / 2018
Content
8 Configuration 22
8.1 LR DEVICE ........................................................................................................................23
8.1.1 Remarks ..................................................................................................................................... 24
8.1.2 IoT: Configure access rights ....................................................................................................... 25
8.1.3 IoT: Configure IP settings ........................................................................................................... 26
8.1.4 IoT: Configure the interface to the LR SMARTOBSERVER ....................................................... 27
8.1.5 Fieldbus: configure Modbus port ................................................................................................ 28
8.1.6 IO-Link ports: Activate data transfer to the LR SMARTOBSERVER .......................................... 29
8.1.7 IO-Link ports: Configure operating mode.................................................................................... 30
8.1.8 IO-Link ports: Set the device validation and data storage .......................................................... 31
8.1.9 IO-Link ports: set fail-safe values ............................................................................................... 32
8.1.10 Info: Show device information .................................................................................................... 32
8.1.11 Firmware: Reset device to factory settings ................................................................................. 33
8.1.12 Firmware: Reboot the device ...................................................................................................... 33
8.1.13 Configure IO-Link devices .......................................................................................................... 34
8.2 IoT Core .............................................................................................................................35
8.2.1 Configure IoT interface ............................................................................................................... 36
8.2.2 Configure the fieldbus port ......................................................................................................... 37
8.2.3 Configure IO-Link ports .............................................................................................................. 37
8.2.4 Set application identification ....................................................................................................... 38
8.2.5 Read / write cyclic process data ................................................................................................. 38
8.2.6 Read diagnostic data .................................................................................................................. 38
8.2.7 Read device information ............................................................................................................. 39
8.2.8 Read information about IO-Link devices .................................................................................... 39
8.2.9 Configure IO-Link devices .......................................................................................................... 40
8.2.10 Control IO-Link master ............................................................................................................... 40
8.2.11 Examples .................................................................................................................................... 41
8.2.12 Programmers' notes ................................................................................................................... 45
8.3 Modbus ..............................................................................................................................49
8.3.1 Integrate the AL1940 into the Modbus project ............................................................................ 49
8.3.2 Set IO-Link master and IO-Link ports ......................................................................................... 51
8.3.3 Read input data of several IO-Link ports .................................................................................... 52
8.3.4 Read input data of individual IO-Link ports ................................................................................. 53
8.3.5 Write output data of several IO-Link ports .................................................................................. 54
8.3.6 Write output data of individual IO-Link ports ............................................................................... 55
8.3.7 Read diagnostic information and events..................................................................................... 56
8.3.8 Read device information ............................................................................................................. 57
8.3.9 Control IO-Link master ............................................................................................................... 57
8.3.10 Configure IO-Link devices .......................................................................................................... 57
8.3.11 Modbus: Programmers' notes..................................................................................................... 58