MAINTENANCE
Ilmor High-Performance Marine, LLC
© 7/2013, Version 1.0
7-5
CHANGE THE FUEL/WATER SEPARATOR
WARNING! Always allow the engine to cool down completely before
attempting to service the fuel/water separator lter in order to avoid re
or explosion.
WARNING! Always be sure that the ignition key is in the OFF position,
the main battery power switch is in the OFF position, and that no spark
or ame are present when servicing the fuel/water separator.
1. Be sure that the key is in the OFF position and that the engine is
completely cooled down.
2. Close the fuel supply valve, if applicable.
3. Locate and remove the fuel/water separator and sealing ring, turning
counterclockwise, being careful not to spill any fuel. Be sure to clean
any spilled fuel immediately.
NOTE: e fuel/water separator is pictured below.
MV10
MV8-570
To Next Page
