ILMOR MV8 570 - SPECIFICATIONS AND SERVICE LOG; GENERAL SPECIFICATIONS; FLUID SPECIFICATIONS

Ilmor High-Performance Marine, LLC
© 7/2013, Version 1.0
11-1
Section 11
SPECIFICATIONS AND
SERVICE LOG
GENERAL SPECIFICATIONS
MV8 570 MV10 650 MV10 725
Full Throttle RPM
Range
5,600–6,000
(6,200 rpm limit)
5,600–6,100 rpm
(6,300 rpm limit)
5,800–6,300 rpm
(6,400 rpm limit)
Displacement 454 cu. in. (7.4 L) 511 cu. in. (8.4 L)
Compression Ratio 10.7:1 10.4:1
Alternator 95 amp 160 amp
Engine Controller 4th Gen. E-Controls ICE system
Emissions Certification
Standard
U.S. EPA – CARB 3-Star Ultra-Low Emissions
and EU RCD (CE) certified
Fuel Type 91 Octane (R+M)/2
(95 RON)
Engine Weight
(including fluids)
830 lb (377 kg) 810 lb (367 kg)
Firing Order 1-8-7-2-6-5-4-3 1-10-9-4-3-6-5-8-7-2
FLUID SPECIFICATIONS
MV8 570 MV10 650
MV10 725
Type Capacity Type Capacity
Engine
Coolant
Sierra Brand
5-Year/100,000-mile 50/50
Mix
2.125 gal
(8 L)
5-Year/100,000-mile
50/50 Mix
4 gal
(15.14 L)
Engine Oil Lucas Oil 20W-50, bottling
date 13086 or later
(shown on bottle label).
Use Mobil 1 20W-50 V-Twin
if Lucas Oil is unavailable.
9 qt
(8.5 L)*
0W-40 Mobil 1
Synthetic
10 qt
(9.46 L)**
Power
Steering Fluid
Synthetic ATF Boat specific Synthetic ATF Boat specific
* 9 qt (8.5 L) for an empty system.
Approximately 6 qt (5.6 L) for an oil change.
** 10 qt (9.46 L) for an empty system.
Approximately 8.5 qt (8.04 L) for an oil change.
NOTE: Always use the dipstick for proper oil level measurement.