TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
BS 400/60 AFI-Eing ED.2011 rev.00 8/60
ALL TRANSPORT AND HANDLING OPERATIONS HAVE TO BE CARRIED OUT WHILE OBSERVING THE
FOLLOWING GUIDELINES:
+ The lifting equipment has to be suited to the size and weight of the machinery to move, with an appropriate
loading capacity.
+ When using equipment such as ropes, chains or lifting belts, special attention has to be paid to their correct
use and positioning in order to not compromise safety and loading capacity.
+ In case lifting belts are in contact with parts of the machine, nylon belts or ropes/chains wrapped with iute or a
clean protection have to be used. When wrapping up and lifting the machine, special care is recommended to
prevent external damages.
+ Handling operations have always to be carried out slowly and carefully, so as to prevent dangerous situations to
persons and things.
+ The personnel in charge of handling operations must observe all local, national and company safety norms
concerning injury prevention and working place.
Transporting the machine with packing at sight
Normally the machine is shipped with a packing at sight, if the means of transport is not open. The machinery is
fixed to a wooden base , then it is wrapped into thermo-plastic material to protect it. After loading it on a truck, it has
to be fixed with belts to hinder any motions. To move around the machine use a forklift with a fork length of more
than 1 meter. It must be lifted from the front side.
WARNING: cover the machine with a canvas if it’s loaded on an open truck.
+ Transport in a wooden cage or case (ON REQUEST, WITH SURCHARGE)
The machine is wrapped into a thermo-plastic covering to assure the protection of all parts, then it is packed in a
wooden cage or case to protect it from collisions and possible bad weather.
To lift it, use a forklift (see picture 1). The machine is fixed inside the wooden packing by means of screws, to
prevent it from moving during the shipment.
You need to follow the indications you find on the packing before proceeding to moving or opening it.
WARNING
The size of the packing varies according to the machine ordered and its configuration.
WARNING
The machine is fixed to the packing by means of screws, so as to hinder that it can move during the transport (see
drawing in the following page)
DO NOT USE THE MOVABLE ARM WITH THE CONTROL PANEL AS LIFTING UP POINT.
In case of following manipulations, the machine should be displaced with the saw frame completely down and the
feeder vice completely close to the machine AND FIXED!.
9 – FITTINGS/ACCESSORIES
The information necessary for the installation are given together with the fittings. Anyway you can find here following
a short description of the product.
To Next Page
Loading...
