Immergas CAR V2 Wireless - 5. SUMMER MODE FUNCTIONS; DHW Temperature Setting; DHW Timer for Storage Tank

19
5. SUMMER MODE FUNCTIONS
With the CAR
V2
in summer mode ( ), only the production
of DHW is enabled.
The boiler produces hot water according to the DHW
temperature set on the CAR
V2
.
5.1 DHW temperature setting.
Turn the selector ( ) to set the DHW temperature (see
Fig. 5-1).
By turning in a clockwise direction the temperature
increases and in an anti-clockwise direction it decreases.
e temperature is memorised aer the selector remains
still for a few seconds.
Fig. 5-1
5.2 DHW timer (for storage tank unit).
If the temperature of the DHW contained in the DHW
storage tank on two distinct levels (comfort and minimum)
is to be regulated, this is possible using the “PR SAN”
function. Regarding this, see the activation mode in the
chapter relative to programming.
The “comfort” temperature corresponds to the value
regulated on the DHW selector. e “minimum” temperature
corresponds to the minimum DHW value envisioned for the
boiler to which the CAR
V2
is coupled.
N.B.: if the CAR
V2
is functioning at minimum temperature
level it is possible to force the DHW temperature by acting
on the DHW selector.
e CAR
V2
is factory set with the DHW always activated on
“comfort” temperature (ON1 00.00 OFF1 24.00).
N.B.: the sanitary timer can also be used to set the time
bands of the device “Aqua celeris” and “recirculation
tank” if provided in in the boiler and depending on the
communication protocol used.