Immergas CAR V2 Wireless - RF Signal and Base Test; Checking the RF Signal Level; CARV2 Base Test Procedure

34
13. CAR
V2
BASE TEST PROCEDURE
e heating request can be forced directly from the CAR
V2
Base. To do so, press the button (ref. 2 Fig. 2-1) for 2 seconds.
e request at the appliance has duration of 30 seconds, aer
which the Base will go back to normal functioning status.
4) Press the OK button on the CAR
V2
;
5) RF>INS will appear to indicate disassociation/removal
has taken place.
12.8 Check the RF signal.
e RF signal level can vary from 0 (none) to 4 (excellent).
Proceed as follows to verify the signal level:
1) Access the protected menu of the CAR
V2
for RF
management (radio frequency): CODE via code “9977”;
2) e Test-RF menu will appear (RF>CHK) indicating the
signal level.