Immergas CAR V2 Wireless - 8. INFORMATION; Accessing Functioning Information; Displayable Parameters

25
8. INFORMATION
By pressing the button, access a menu that allows
to verify the functioning state of the CAR
V2
remote control.
If a determined value is not present “--” will be displayed.
e display of the “info” is subject to the boiler model and
the method of connection of the CAR
V2
remote control.
Press the button repeatedly to scroll the list .
To go back to normal functioning mode, press the
button or wait 60 seconds.
e parameters that can be displayed are listed below:
- T EST: external temperature (the optional external
temperature probe if present).
- T MAND: central heating circuit ow temperature.
- RITORN: central heating circuit return temperature.
- TI SAN: DHW input temperature.
- TO SAN: DHW output temperature.
- TC SOL: solar collector temperature.
- PRESSI: system pressure, central heating circuit.
- MANUTZ: days remaining before periodic maintenance.
- VER P “x”: “x” identies the type of communication
protocol with the boiler in use:
VER PC = CAR-Bus; VER PI = IMG-Bus.
e display shows the rmware version of the CAR
V2.
remote control
- ZONE: not used on this model.
N.B.: the sizes displayed depend on the type of boiler to
which the CAR
V2
is connected.