Immergas CAR V2 Wireless - 1. INSTALLATION; Installation Recommendations; Installation Operations

6
1. INSTALLATION
1.1 Installation recommendations.
e CAR
V2
, including the relative cables and connections
to the boiler, must be installed by specialised sta. On the
free initial check of the boiler, when the CAR
V2
is inserted
into the system, the Immergas authorised aer-sales centre
checks the connection to the generator terminal board
and adjusts functioning. e free check just of the CAR
V2
is not envisioned by the Immergas authorised aer-sales
centre is requested successively to the start phase of the
boiler warranty.
Important: installation of the CAR
V2
base wires are not
included in the free checks of the boiler and is to be carried
out by the installer company.
N.B.: follow the installation sequence by rst installing the
Base and then the CAR
V2
.
1.2 Installation operations.
1) Separate the xing bottom from the lid of the CAR
V2
Base using a screwdriver as a lever in the relative recess
(Fig. 1-1). Pull the lid manually outwards to separate it
from the bottom.
2) Install the CAR
V2
Base bottom using the openings on
its rear part onto the wall or onto a recess box using the
relative supplied screws (Fig. 1-2).
1
3
2
Fig. 1-1