What does it mean if my Immergas Victrix Pro 80 2ErP Boiler displays a return NTC probe outside the operating range, and what can I do?
If the board detects an open contact on the return NTC probe of your Immergas Boiler, press the Reset button.
What does it mean when my Immergas Victrix Pro 80 2ErP shows an overheating block, and what should I do?
If your Immergas Boiler overheats during normal operation due to a fault, it will go into an overheating block. To resolve this, press the Reset button.
What should I do if my Immergas Victrix Pro 80 2ErP Boiler displays a flame circuit anomaly?
If your Immergas Boiler detects an anomaly in the electronic flame control circuit during ignition and shuts off, press the Reset button.
What to do if my Immergas Victrix Pro 80 2ErP displays insufficient system pressure?
If your Immergas Boiler switches off due to low system pressure, check the pressure gauge. Ensure the pressure is between 1 and 1.2 bar, and restore it if necessary.
What to do if my Immergas Boiler has a parasite flame block?
A parasite flame block during power-on can occur due to a leak in the detection circuit or an issue with the flame control unit. In this case, press the Reset button.
What does it mean if my Immergas Victrix Pro 80 2ErP Boiler displays a fan signal anomaly, and how do I fix it?
A fan signal anomaly on your Immergas Boiler indicates the fan speed is incorrect. To attempt to resolve this, press the Reset button.
What does it mean if my Immergas Boiler displays a flow and return NTC probe connection error, and what should I do?
If the electrical connection between the two NTC probes is switched around, the board will detect the anomaly. It may be necessary to wait 3 minutes for the error to be detected. In this case, press the Reset button.
What does it mean if my Immergas Victrix Pro 80 2ErP Boiler displays a return NTC probe in short circuit, and what should I do?
If the board detects a short circuit on the return NTC probe of your Immergas Boiler, press the Reset button.
What does it mean if my Immergas Victrix Pro 80 2ErP displays a flow NTC probe in short circuit, and what should I do?
If your Immergas Boiler's board detects a short circuit on the flow NTC probe, press the Reset button.
What does it mean if my Immergas Boiler displays a flow NTC probe outside the operating range, and what can I do?
If the board detects an open contact on the flow NTC probe of your Immergas Boiler, press the Reset button.
To Next Page
General