Immergas Victrix Pro 80 2ErP - Very Low Voltage Wiring Diagram

30
3-3
3
2
1
1
INSTALLERUSER
MAINTENANCE TECHNICIAN
For "WE-BUS", "0-10", "Simple BUS cascade"
connection, remove the X40 bridge.
A thermostat can be used instead of B2 (set the
P29 = 17 parameter).
e "Remote control for single high power boiler"
must be connected to the "M" and "O" terminals
(set the address to zero).
Congure the corresponding parameters when
connecting in “simple cascade”, or when con-
necting in “system side ow probe”, or “D.H.W.
p u m p”.
3.3 VERY LOW VOLTAGE WIRING DIAGRAM.
Key: A2 - Electronic board A4 - Display board B1 - Flow probe B1-2 - System side ow probe (optional) B2 - Domestic hot water probe (optional) B4 - External temperature probe (optional) B5 - Return probe B10 - Flue probe
E4 - Safety thermostat E5 - -Heat-exchanger safety thermostat
(manual reset)
E13 - Flue safety thermofuse M1 - Boiler circulator pump M20 - Fan S5 - System pressure switch S6 - Air pressure switch S20 - ON/OFF room thermostat (optional) X40 - Room thermostat jumper
1 - Testing 2 - “Simple cascade” communication bus 3 - 0 - 10 V analogue input
Colour key: BK - Black BL - Blue BR - Brown G - Green GY - Grey OR - Orange P - Purple PK - Pink R - Red Y - Yellow Y/G - Yellow / Green W - White W/BK - White / Black