Immergas Victrix Pro 80 2ErP - Circulation Pump; Kits Available on Request

17
1-24-A
Victrix PRO 80 2 ErP
A
B
INSTALLERUSER
MAINTENANCE TECHNICIAN
1.25 KITS AVAILABLE ON REQUEST.
• Cascade and zones heat adjuster kit.
• Support kit for xing the heat adjuster to the
wall.
• Zone manager kit.
• Modulating room thermostat kit.
• External probe kit.
• System ow probe kit.
• DHW probe kit for external storage tank.
• Anti-freeze with -15 °C resistance kit.
• Individual boiler safety devices stub pipes kit.
• Boilers in cascade safety devices stub pipes kit.
• ree-way valve kit for coupling external stor-
age tank unit.
• Individual boiler hydraulic manifold kit.
1.24 CIRCULATION PUMP.
e boilers are supplied with a variable speed
circulator pump.
When the boiler is in the heating phase, pump
speed is dened by the setting of the parameters
“P27” and “P28” and varies so as not to exceed
the ∆T of 18 °C.
In domestic hot water mode the circulator pump
always runs at maximum speed.
Pump release. If, aer a prolonged period of
inactivity, the circulation pump is blocked,
unscrew the front cap and turn the motor sha
using a screwdriver. Take great care during this
operation to avoid damage to the motor.
• Hydraulic connection manifolds kit with two
boilers in cascade.
• Additional boiler in cascade hydraulic manifold
kit.
• Flue exhaust manifold kit with ue adjusting
devices with two boilers in cascade.
• Flue exhaust manifold kit with ue adjusting
device with additional boiler in cascade.
• 80/125 Ø horizontal concentric kit.
• 80/125 Ø vertical concentric kit.
• 80 Ø horizontal kit with ue exhaust.
• 80 Ø horizontal terminal kit with wall ue
exhaust.
• 80 Ø vertical terminal kit.
e above-mentioned kits are supplied complete
with instructions for assembly and use.
Head available to the system.
Flow rate (l/h)
Head (kPa)
Key:
A = Available head
B = Power absorbed by the circulator
pump (dotted area)
Circulator pump absorbed power (W)