What does it mean if my Immergas Victrix Pro 80 2ErP Boiler displays a return NTC probe outside the operating range, and what can I do?
If the board detects an open contact on the return NTC probe of your Immergas Boiler, press the Reset button.
What does it mean when my Immergas Victrix Pro 80 2ErP shows an overheating block, and what should I do?
If your Immergas Boiler overheats during normal operation due to a fault, it will go into an overheating block. To resolve this, press the Reset button.
What should I do if my Immergas Victrix Pro 80 2ErP Boiler displays a flame circuit anomaly?
If your Immergas Boiler detects an anomaly in the electronic flame control circuit during ignition and shuts off, press the Reset button.
What to do if my Immergas Victrix Pro 80 2ErP displays insufficient system pressure?
If your Immergas Boiler switches off due to low system pressure, check the pressure gauge. Ensure the pressure is between 1 and 1.2 bar, and restore it if necessary.
What to do if my Immergas Boiler has a parasite flame block?
A parasite flame block during power-on can occur due to a leak in the detection circuit or an issue with the flame control unit. In this case, press the Reset button.
What does it mean if my Immergas Victrix Pro 80 2ErP displays 'Flow and return NTC probe temperature detection incorrect'?
If your Immergas Boiler displays this error, the board has detected a sudden drop in temperature on one of the two NTC probes (flow and return), possibly due to the failure of one of the probes. To address this, press the Reset button.
What does it mean if my Immergas Boiler displays 'Poor thermal flow NTC probe contact'?
If your Immergas Boiler displays this error, the board isn't detecting a change in the flow NTC probe temperature during operation, possibly due to a poor thermal probe contact or a system with excessive thermal inertia. To attempt to resolve this, press the Reset button.
What does it mean if my Immergas Victrix Pro 80 2ErP displays 'Poor thermal return NTC probe contact'?
If your Immergas Boiler displays this error, the board isn't detecting a change in the return NTC probe temperature during operation, possibly due to a poor thermal probe contact or a system with excessive thermal inertia. To attempt to resolve this, press the Reset button.
What does it mean if my Immergas Victrix Pro 80 2ErP Boiler displays a return NTC probe in short circuit, and what should I do?
If the board detects a short circuit on the return NTC probe of your Immergas Boiler, press the Reset button.
What does it mean if my Immergas Victrix Pro 80 2ErP displays a flow NTC probe in short circuit, and what should I do?
If your Immergas Boiler's board detects a short circuit on the flow NTC probe, press the Reset button.
To Next Page
General