Immergas Victrix Pro 80 2ErP - 3.12 Programming the boiler P.C.B.

43
INSTALLERUSER
MAINTENANCE TECHNICIAN
3.12 PROGRAMMING THE BOILER P.C.B.
e boiler is prepared for possible programming of several op-
eration parameters. By modifying these parameters as described
below, the boiler can be adapted according to specic needs.
- Access programming by pressing and holding down buttons “B”
and “C”
45
- Scroll through the parameters by pressing the + and - heating
adjustment buttons,
46
- Change the parameter by pressing the + and - DHW adjustment
buttons.
47
- Save the parameters by switching from one parameter to the next
or by pressing “B”.
48
- Exit the programming mode by pressing and holding down
buttons “B” and “C”, or wait approximately 2 minutes without
touching the buttons. e boiler will then run a self-diagnosis
of the parameters by displaying “PARA” followed by “Auto”.
- While the value of a parameter is being displayed, press “B”
quickly to see the code again.